BasicBench

The BasicBench subassembly inserts links to create cut or fill catch slopes with repeating benches as needed. You can define a swale width and depth at the benches. The last daylight slope to the target surface may be different than the bench slope.

Attachment

The attachment point is at the inside edge of the initial cut or fill slope. This component can be attached to either the left or right side.

Input Parameters

Note: All dimensions are in meters or feet unless otherwise noted. All slopes are in run-over-rise form (for example, 4 : 1) unless indicated as a percent slope with a “%” sign.

Parameter	Description	Type	Default
Side	Specifies which side to place the subassembly	Left / Right	Right
Max Daylight Height	The maximum allowable height for the cut and fill daylight link without benching.	Numeric	15.0 ft 4.5 m
Bench Height	The maximum allowable height for a bench before a new bench.	Numeric	10.0 ft 3.0 m
Bench Slope	The slope between benches.	Numeric, positive	1 (: 1)
Bench Grade In	The +/- % slope of the bench. Positive slopes are upward in the direction of increasing offset.	Numeric	4 (%)
Bench Width In	The width of the bench to the bench flowline.	Numeric, positive	4 ft 1.2 m
Bench Grade Out	The +/- % slope of the bench. Positive slopes are upward in the direction of increasing offset.	Numeric	4 (%)
Bench Width Out	The width of the bench from the bench flowline.	Numeric	4 ft 1.2 m
Daylight Slope	The daylight slope.	Numeric, positive	2 (: 1)

Target Parameters

This section lists the parameters in this subassembly that can be mapped to one or more target objects. For more information, see To Specify Corridor Targets.

Parameter	Description	Status
Daylight Surface	Name of the daylighting surface. The following object types can be used as targets for specifying the surface: surfaces.	Required

Runtime Logical Assignments

None.

Output Parameters

None.

Behavior

The initial hinge point is set at the attachment point. The hinge point elevation is checked against the target surface to determine if the section is in the cut or fill condition. An intercept is calculated to the target surface using the given Daylight Slope. If the height to the intercept exceeds the Max Daylight Height, the link with the Bench Height is inserted, and the bench is added. The hinge point is reset to the outside edge of the bench and the process is repeated until a daylight link is found that does not exceed the Max Daylight Height.

This subassembly contains a loop definition comprised of L2, L3, and L4 that is repeated until it reaches the surface target or until it is repeated a maximum of 10 times.

Layout Mode Operation

In layout mode, this subassembly draws the initial fill slope to 5 units.

Point, Link, and Shape Codes

The following table lists the point, link, and shape codes for this subassembly that have codes assigned to them. Point, link, or shape codes for this subassembly that do not have codes assigned are not included in this table.

Point, Link, or Shape	Code	Description
P1 - P5	Top
P5	Daylight	Daylight point, and daylight point for either the cut or fill condition. This only applies to the actual daylight point.
L1 - L4	Top