Get Mark Point
Add a marker point on or near a subassembly.
Note: The Get Mark Point element appears in the final subassembly geometry. To add a mark point that does not appear in the final subassembly geometry, use the Auxiliary Mark Point element.
Properties
Specify the following parameters in the Properties panel.
| General | |
| Mark Name | Specifies the name of the mark point. |
| Point | |
| Point Codes | Specifies the codes assigned to the point. |
| Point Number | Specifies the point number. You can change the automatically generated value. |
| Preview | |
| From Point | Specifies the point to which the mark point position is relative. |
| Delta X | Specifies the horizontal offset relative to the From Point. Click [...] to open the Expression Editor, where you can enter or calculate a value. |
| Delta Y | Specifies the vertical offset relative to the From Point. Click [...] to open the Expression Editor, where you can enter or calculate a value. |
| Miscellaneous | |
| Comment | Indicates notes about the point. Comments can be displayed in the Preview panel. |
Example
To see an example of how this geometry element is used, open the following Sample PKT file:
Get Mark Point Example.pkt
In the example, P4 is the mark point. The Delta X and Delta Y values are both 0.5 from P3, which slopes from P2 to the target surface. As the surface elevation changes, P4 maintains its position relative to P3.
