Expand Arm Geometry and click on the Approach tab.
The Design Speed is the design speed of the section of road leading up to the roundabout.
The Central Gap Width is the distance between the offside definition lines of the approaching lanes and the departing lanes.
The Deviation Offset defines the section of road that follows the original alignment before horizontal deflection is applied.
Deflection (or center line offset) is the distance that the alignment is adjusted to the left or right of the zero deflection point. Zero deflection occurs when the alignment meets the ICD on a bearing that passed through the center of the roundel. Deflection is used to adjust drivers speed.
The Approaching Lanes is the number of lanes of traffic approaching the roundabout and would normally be less than or equal to the number of circulatory lanes. Select a value from the drop down list.
The Approaching Lane Width is measured between definition lines. On a road with no center gap the offside definition line is the centerline.
The Departing Lanes is the number of lanes leaving the roundabout onto this road. Select a value from the drop down list.
The Departing Lane Width is measured between definition lines. On a road with no center gap the offside definition line is the centerline.
In all cases the Max and Min values represent the limiting values from the adopted design standard and the Default value will be used when the roundabout is first placed. A default value MUST be provided but Max and Min may be blank if there is no limiting value.