To Add Assemblies to Corridors at Offset Target Geometry Points

You can automatically add assemblies to a corridor at offset target object (feature line or alignment or polyline) geometry points. This feature is specified in the command settings for the CreateCorridor command. By default, the command setting option for this behavior is set to Yes. If you do not want newly created corridors to automatically add assembly insertion stations, set this to No.

You can also specify this option on individual corridors that already exist in the drawing.

Note: Using this feature adds additional stations to the corridor at the offset targets geometry points. Therefore, if you have large or complex corridors, you may notice an increase in the time it takes to rebuild corridor models. It is important to note, though, that the corridor stations are only being added based on the horizontal, and not on the vertical, geometry points of the offset targets.

To automatically add assemblies at offset geometry points using command settings

1. In Toolspace, click the Settings tab.
2. Expand CorridorCommands.
3. Right-click CreateCorridor, and click Edit Command Settings. In the Edit Command Settings dialog box, and then expand the Assembly Insertion Defaults property group.
4. Set the Value field for the Offset Target Geometry Points to Yes to enable this option.
5. Click Apply or OK.

To automatically add assemblies at offset geometry points on an existing corridor

1. In Toolspace, right-click a corridor and click Select.
2. Click Corridor tabModify Region panelEdit Frequency Find.
3. Select the desired corridor region.
4. In the Frequency to Apply Assemblies dialog box, expand the Apply Assembly node.
5. Set the Value field for the At Offset Target Geometry Points to Yes to enable this option.
6. Click OK.