To Send Coordinate Tracker Values to the Current Command

1. Display the Coordinate Tracker. Select a surface if required.
2. Run any command until you are prompted at the command line for a 2D point, a 3D point, or an elevation.
3. Move the cursor until the Coordinate Tracker displays the desired coordinate and elevation values.
4. To suspend cursor tracking and capture the current X, Y, and Z coordinate values, do the following:
   • Enter the keys listed in the Coordinate Capture Keys edit box by pressing, and not releasing, each key in the specified order until you are holding all the specified keys down.
   • Release all keys.

   Coordinate tracking is suspended and the current X, Y, and Z coordinates are captured.

5. Optionally, edit the coordinate information before sending it. In the Coordinate Tracker, click in either the X:, Y:, or Z: edit box and enter a new value.
   Tip: Move the cursor over each button to view a tooltip that tells you what value the button sends to the command line.
6. Do one of the following:
   • To send the X and Y values, click .
   • To send the Z value only, click .
   • To send X, Y, and Z values, click .
7. After you send a value, cursor tracking is automatically resumed. To resume cursor tracking without sending a value, click .