Use this dialog box to select the corridors and specify sample line groups for a cross section slope stake report. This report identifies the points of slope change for a selected corridor link.
Specifies the corridors to include in the report. Only corridors that are based on alignments with defined sample line groups are displayed.
Select a corridor from the list or click to select a corridor from the drawing.
Specifies the alignment to include in the report. Only the alignments contained in the selected corridor are displayed.
Specifies the sample line group to include in the report. Only the sample line groups for the selected alignment are displayed.
Specifies which corridor link to use in the report. A link is defined as a single straight-line segment between endpoints on a subassembly.
Adds the selected corridor, alignment, and sample line group to the List of Corridors to include in the report.
Lists the corridors to include in the report.
Lists the alignment and sample line group that you selected.
Displays the start and end stations for the selected sample line group.
You can edit these values using the Report Settings (see below).
Removes the corridor from the list.
Displays the start and end stations for a highlighted sample line group. Click a sample line group name in the list to highlight it.
You can edit these values to change the range of stations included in the report. You can enter formatted or unformatted values, such as 2+50.95 or 250.95.
Specifies the name and location of the resulting report.
Generates the report and saves it to the specified location.
Closes the dialog box and discards changes to station ranges.
The slope stake report has data formatted in columns. The end columns contain information about the last two offsets in the corridor. The other columns contain information about the point codes.
For example:
C 8.47
@33.87
S 1:4.00
For example:
Daylight
-110.369
629.991
1:-4.00