Specifies the raster stamp printed during output.
The Raster Stamp tab controls the raster stamp printed on the output print.
You can load the printer with predefined raster stamps, which are identified by stamp names. You define stamp names for this driver by using the Edit Stamp Names dialog box. The stamp names that you define should match the names that are defined in the printer.
When you define a stamp name in the Edit Stamp Names dialog box, the name appears in the Raster Stamp Selection drop-down list.
When you select a user-defined stamp name, fields on the Raster Stamp tab are enabled that allow you to select stamp scaling, scaling type, and placement.
The Raster Stamp tab contains the following options:
Controls which raster stamp (if any) to be used on printed output.
Overrides the printer raster stamp setting. No raster stamp is output.
Specifies that the printer defines the control for raster stamp output.
Specifies the names that are defined through the Edit Stamp Names dialog box.
Opens the Edit Stamp Names dialog box, in which you can define raster stamp names for the driver. The names should match those defined in the printer. Once defined, the names are available on the Raster Stamp Selection drop-down list.
Specifies the output size of a loaded raster stamp. You can specify a scaling factor of 10 through 999. The scaling factor can be either Relative to Drawing or Absolute.
Controls the printed location of a raster stamp.
You can set the X position to Left, Center, Right, or Absolute in inches or millimeters.
You can set the Y position to Top, Center, Bottom, or Absolute in inches or millimeters.
You can set the rotation to 0, 90, 180, or 270 degrees.