Flat Pulley Properties dialog box

Set up properties of a flat pulley.

Access:

Ribbon: Design tab

Power Transmission panel

Synchronous Belts and click the Design tab. On the Pulleys section, click Pulley Properties.

Note: This dialog box is displayed only if you select the Flat Pulley.

OK	Click to confirm the selection and close the dialog box. Enters the values to the Design tab.
Cancel	Closes the dialog box.

Design Guide	Designs the pulley size based on the transmission ratio rather than setting up driven pulley size manually. For a standard driven pulley, the generator finds closest pulley size to accomplish the appropriate transmission ratio.
Custom size	Specifies the custom pulley size. By default, the pulley size is standard. It is driven by a data table stored within the Design Data folder. The data template is a fast and easy way to set up pulley size by changing the diameter of the pulley. If the custom size option is switched on, you are responsible for all pulleys' properties.
	You can change the belt direction to counterclockwise to change the motion direction.