| G3024
|
FATAL ERROR: G3024
|
elemtype ELEMENT
id HAS AN EDGE POINT RATIO GREATER THAN
tol
|
|
|
Cause:
|
The specified element has an edge point to length ratio greater than the preset warning tolerance (dependent on element type):
HEXMAXEPLRTOL, PENTMAXEPLRTOL, PYRMAXEPLRTOL, TETMAXEPLRTOL, QUADMAXEPLRTOL, and TRIMAXNEPLRTOL.
|
|
|
Action:
|
Perform the following depending on the element type referenced:
- If the edge point to length ratio is excessive, consider remeshing the applicable region or adjusting the edge node position towards the midpoint.
- For hex elements set the
HEXINODE model parameter to ON.
- For quad elements set the
QUADINODE model parameter to ON.
- For quad elements set the
SHELLRNODE model parameter to ON.
|
|
|
Remarks:
|
See Autodesk Nastran Reference Guide, Section 5,
Parameters, for more information.
|