Size page (Options Dialog)

Specify the sizes of points and markers displayed in the CAD view.

 Ribbon: File tab Options Application Options Display Options Size

The following options are displayed.

• Fix size of confetti — Control the size at which inspection point confetti spots are displayed in the CAD view:

  • Diameter of confetti — Clear to scale inspection-point confetti spots as you zoom in and out of the CAD view and enter the relative point size.
  • Diameter of fixed size confetti — Display inspection-point confetti spots at a specified size irrespective of the CAD view magnification and enter the absolute point size.
• Fix size of geometric discs — Control the size at which geometric discs are displayed in the CAD view:

  • Diameter of geometric discs — Clear to scale geometric discs as you zoom in and out of the CAD view and enter the relative disc size.
  • Diameter of fixed size geometric discs — Display geometric discs at a specified size irrespective of the CAD view magnification and enter the absolute disc size.
• Scale of geometric confetti — Scale the pins and form-tolerance zone used in geometric feature mode.

  Specify 1 to display the pins and tolerance zone at actual size.

• Scale of probe in the CAD view — Scale the probe when displayed in the CAD view.

  This value also scales the probe-point indicators displayed in full-screen mode when the bouncing-ball feature is enabled.

• Size of points in a point-cloud — Display size, in pixels, for points in a point-cloud.
• Size of guided point targets — Size of the target and arrow used to indicate the position of guided points.
• Size of edge point triangles — Size of the triangles used to indicate the position of edge points.
• Size of nominal guided point arrows — Size of the arrow used to indicate the vector of nominal guided points.
• Size of geometric datum — Size of the graphic used to display an alignment or datum.
• Size of reference marks — Size of the graphic used to display reference marks in the 6 Degrees of Freedom application.
• Diameter of digitised curve point spheres — Size of the spheres used to indicate the position of points in digitised curves.
• Default line thickness for probe paths — Size, in pixels, for the line thickness of probe paths.

Note: You can view and change the current units of the document in the General tab of the Measure Parameters dialog.