PowerMill 2023.0.1 update
The fixes in PowerMill 2023.0.1.
| Toolpath fixes |
| A problem has been fixed that could cause PowerMill to close unexpectedly when calculating a Steep and Shallow Finishing toolpath with the Optimise Open Pockets option selected. PMILL-18288 |
| A problem has been fixed that could result in an incomplete toolpath when the model included surfaces whose Machining Mode had been set to Collision. PMILL-17878, PMILL-18284, PMILL-18296 |
| An inefficiency in the calculation of 3D Offset Finishing toolpaths has been removed. PMILL-18157 |
| Toolpath editing |
| A problem has been fixed that could cause edits to the leads and links within a toolpath not to be saved in a project if the toolpath's cutting moves had not also been modified. This would result in an inconsistency between the toolpath's moves and its parameters, for example, start and end point parameters. This problem was introduced in PowerMill 2022. PMILL-18025, PMILL-17523, PMILL-17975, PMILL-17756, PMILL-16718, PMILL-17493 |
| General fixes |
| An issue has been resolved that prevented toolpaths from being properly recovered if they are contained within a setup that contained folders. PMILL-18359 |
| Some drawing issues have been addressed that caused the block and the stock to be incorrectly displayed together following activation of a setup or adding a toolpath to a setup. PMILL-17507 |
| An issue causing PowerMill to close unexpectedly when reading in a corrupt project has been resolved, allowing the remainder of the project to be opened. PMILL-17970 |
| Fixed an issue that caused PowerMill to close unexpectedly if an NC Program is deleted followed by the deletion of the toolpaths, setups, or workplanes that were in the NC Program and then recover the NC Program without also recovering the toolpaths, setups, or workplanes. PMILL-10041, PMILL-17098 |
| Improved the error messages when PowerMill fails to create a setup sheet because the pathname is too long. PMILL-16700 |
| Security |
| The version of OpenSSL used in PowerMill has been upgraded to v1.1.1n to meet security recommendations. DCTVD-1680 |
| Customer error reporting (CER) fixes |
| A potential issue causing PowerMill to close unexpectedly when interacting with the strategy dialogs has been resolved. This issue was identified by CER. PMILL-18264 |
| A problem has been fixed that could cause PowerMill to close unexpectedly when calculating a rest boundary that was defined relative to another boundary. This issue was identified by CER. PMILL-17797 |
| A problem has been fixed that could cause PowerMill to close unexpectedly when calculating a boundary around the flat areas of the model. This issue was identified by CER. PMILL-18192 |