The Wall Joins tool is not recommended for editing wall joins that involve more than 4 walls, span multiple floors, or exist in more than one workset. For these more complex joins, use the following basic procedure to edit individual walls as needed.
Note: Complex wall joins can have many possible configurations. You may have to step through hundreds of them to find the desired one.
- If applicable, set all involved worksets to editable.
- Select one of the joined walls, and use its Drag Wall End control to move it out of the join.
- Drag the wall end back to a different location within the join.
Tip: Use snap points, snap lines, and the feedback on the status bar to help pinpoint the new location.
- If the automatically created join does not produce the desired configuration, you can disallow joins for the joined end of the selected wall, move it again, and then re-create the join using the Join Geometry tool.
- Repeat the previous 3 steps as needed for the selected wall and others in the join.