CIS/2-Dateireader
Der CIS/2-Dateireader unterstützt die vom Amerikanischen Stahlbauinstitut (American Institute of Steel Construction, AISC) festgelegten CIS/2-Normen (CIMSteel Integration Standards) als Format für den Datenaustausch zwischen stahlbezogenen CAD-Programmen.
Unterstützte Elemente
- Assembly_design
- Assembly_design_child
- Assembly_manufacturing
- Analysis_model_3d
- Part_derived
- Part_prismatic_simple
- Part_sheet_bounded_complex
- Part_sheet_bounded_simple
- Section_profile_compound
- Section_profile_derived
- Section_profile_edge_defined
- Section_profile_angle
- Section_profile_channel
- Section_profile_circle
- Section_profile_circle_hollow
- Section_profile_i_type
- Section_profile_i_type_asymmetric
- Section_profile_i_type_rail
- Section_profile_rectangle
- Section_profile_rectangle_hollow
- Section_profile_t_type
- feature_volume_prismatic_chamfer
- feature_volume_prismatic_flange_notch
- feature_volume_prismatic_flange_chamfer
- feature_volume_prismatic_notch
- feature_volume_prismatic_skewed_end
- Element_curve_simple
- Element_node_connectivity
- Element_eccentricity
- Located_joint_system
- Design_joint_system
- Joint_system_mechanical
- Fastener_mechanism
- Fastener_simple_bolt
- Fastener_simple_shear_connector
Nicht unterstützte Elemente
- Part_complex
- Part_prismatic_complex
- Part_sheet_profiled
- Section_profile_centreline
- feature_cutting_plane
- feature_edge_chamfer
- feature_surface
- feature_thread
- feature_volume_complex
- feature_volume_curved
- feature_volume_hole
- Element_volume
- Element_surface
- Element_point
- Element_curve_complex
- Element_with_material
- Joint_system_amorphous
- Joint_system_chemical
- Joint_system_welded
- Weld_mechanism
- Joint_system_complex
- Fastener_simple_nut
- Fastener_simple_washer
- Fastener_simple_stud
- Fastener_simple_pin
- Fastener_simple_nail
- Fastener_simple_screw
- Fastener_simple_countersunk
- Fastener_simple_curve
- Fastener_simple_complex
Unterstützte Schnittprofil-Grundtypen
Der Dateireader unterstützt die folgenden Schnittprofil-Grundtypen:
- I-Träger
- Tee
- Winkel
- U-Profil
- Kreis
- Rechteck
- Doppelwinkel
- Querbalken
Unterstützte AISC-Schnittprofiltypen
Der Reader unterstützt alle nach AISC definierten Schnittprofiltypen, und ordnet diese den Schnittprofil-Grundtypen zu:
- I-Träger: HP, M, S, W
- Tee: MT, ST, WT
- Winkel: L, LP
- U-Profil: C, MC
- Kreis: HSRO, P, PX, PXX, RB
- Rechteck: HSRE, HSSQ, SB, TS
- Doppelwinkel: DL, DLL, DLS