Create Reports - Profile Incremental Chainage Report

Use this dialog box to select the profiles and specify chainage ranges for a profile incremental chainage report.

This report lists VIP chainages and levels of the selected profile at regular intervals, at critical geometry points, and crest and sag curve points.

List of Profiles

Include

Specifies the profiles to include in the report. Select a check box to include the profile.

Name & Description

Displays the name and description of the profiles in the drawing.

Chainage Start & Chainage End

Displays the start and end chainages for a selected profile.

You can edit these values by highlighting a profile in the list and adjusting the Report Settings (see below).

Alignment

Displays the horizontal alignment that the profile is associated with.

Report Settings

Start Chainage & End Chainage

Displays the start and end chainages for a highlighted profile. Click a profile name in the list to highlight it.

You can edit these values to change the range of chainages included in the report. You can enter formatted or unformatted values, such as 2+50.95 or 250.95.

Chainage Increment

Specifies the chainage increment to use. For example, specify 50 to report at increments of 50 feet or meters along the profile.

Note: The start and end chainages are always included in the report. The increment starts at the beginning chainage, even if it is an odd value. The increment is applied to all profiles.

Save Report To

Specifies the name and location of the resulting report.

Create Report

Generates the report and saves it to the specified location.

Done

Closes the dialog box and discards changes to chainage ranges.