To Zoom to a Point

You can zoom to a point name, point number, or a range of point numbers. You can run this command at the command line or as a transparent command from within another command.

If a point is not in the current drawing a message is displayed at the command line. If a point included in a series of points is missing, then it is ignored and the location of all the other points will be used.

To zoom to a point

• On the ribbon, click COGO Points contextual tab COGO Point ToolsZoom To Point Find. At the command line, enter the point name or number.

To zoom to a list of points

• At the command line, enter ztp and then enter point numbers separated by commas.

To zoom to a range of points

• At the command line, enter ztp and then enter the range of points separated by a hyphen.

To transparently zoom to a point from within another command

• Click Transparent tab Plan panel Zoom To Point Find.
• Right-click to display the Transparent Commands context menu Zoom To Point.
• Activate the Transparent Commands toolbar and select Zoom To Point .
• At the command line, enter 'ztp and then enter a point name, point number, or a range of point numbers.

  After you run the command as a transparent command, the command line returns to the main command after a single zoom.

Note: At the command line you can enter a comma delimited list that contains both point numbers and point names.