Create Reports - Cross Section Points Report

Use this dialog box to select the corridor, alignment, and feature lines, and to specify a chainage range and chainage interval for a cross section points report.

This report lists the point coordinates at a specified chainage interval for points that belong to a given corridor cross section. The report lists X,Y,Z coordinates, the offset from centerline, and the point code for the point-code-based feature line that is sectioned.

Select Report Components

Select Corridor

Specifies the corridor on which to base the report.

Select Alignment

Specifies the alignment on which to base the report.

Filter By Link Code

Specifies whether to filter the List of Feature Lines by link codes to make selection easier. For example, selecting the SubBase link code may filter the list of feature lines to just Daylight_Sub and ETW_Sub.

List of Feature Lines

Select

Specifies the corridor feature lines to include in the report. Select a check box to include the feature line.

Note: By default, all identical point codes are connected as longitudinal feature lines.
Point Codes

Displays the names of the point codes in the corridor subassembly that are connected to form the feature lines.

Report Settings

Start Chainage & End Chainage

Specifies the start and end chainages to include in the report.

Chainage Increment

Specifies the chainage increment to use. For example, specify 50 to report at increments of 50 feet or meters along the corridor.

Save Report To

Specifies the name and location of the resulting report.

Create Report

Generates the report and saves it to the specified location.

Done

Closes the dialog box and discards changes to chainage ranges.