One of the factors used to assess the safety of a roundabout is the maximum realistic speed of a notional vehicle on the most direct line (the fastest line) through the roundabout. This is known as the fastest line speed. To calculate the fastest line speed, Roundabouts first calculates the required alignment and then steps along it testing for the smallest radius. The smaller the radius, the slower the speed. The speed is calculated using the following equation:
V2 = 127R(e+f)
Where:
Expand Fastest Path Analysis and click Fastest Path Calculation in the left hand pane. The Fastest Path Calculation page is displayed.
The method by which the fastest line is calculated varies and differing methods often give different answers. The settings on this page let you adjust how the calculation is done.
The following offsets may be measured from definition lines or kerb lines and from island or apron. Use the Offset Path From drop-down list to select the required method.
The Start Distance from Yield Line is the straight line distance from the inscribed circle to the front axle of the test vehicle.
The Start Centreline Offset is the minimum offset from the nearside or offside kerbs or definition lines.
The Entry Offset is the minimum offset of the centreline of the vehicle from the nearside entry kerb or definition line.
The Island Offset is the minimum offset of the centreline of the vehicle from the island or apron.
The Exit Offset is the minimum offset of the centreline of the vehicle from the nearside exit kerb or definition line.
The End Centreline Offset is the minimum offset from the nearside or offside kerbs or definition lines.
The End Distance from Exit Line is the straight line distance from the inscribed circle to the front axle of the test vehicle.
The Radius Calculation Length is the length over which the radius should be tested. Roundabouts calculates the radius of a 3-point arc of this length along the fastest line using the start, middle and end points.
The fastest line and speed are calculated continuously and optionally displayed in the HUD or Roundabout Report.
In all cases the Max and Min values represent the limiting values from the adopted design standard and the Default value will be used when the roundabout is first placed. A default value MUST be provided but Max and Min may be blank if there is no limiting value.