To Specify Gap Between the Center Mark and its Centerlines

Control the gap between the center mark and its centerlines.

Specify the Default Gap Between a New Center Mark and its Centerlines

1. At the Command prompt, enter CENTERCROSSGAP.
2. Specify a new value. You can enter any of the following:
   • Relative value - any positive real number followed by x.
   • Absolute value - any positive real number
   • ByLineType

Specify the Gap Between an Existing Center Mark and its Centerlines

1. If the Properties Inspector is not displayed, select Modify Properties.
2. Select one or more center marks.
3. In the Properties Inspector All tab, under Geometry, select Cross Gap.
4. Specify a new value.