To Specify the Size of a Center Mark

Control the size for new and existing center marks.

Specify the Default Size for New Center Marks

1. At the Command prompt, enter CENTERCROSSSIZE.
2. Specify a new value. You can enter any of the following:
   • Relative value - any positive real number followed by x.
   • Absolute value - any positive real number
   • ByLineType

Specify the Size for Existing Center Marks

1. If the Properties Inspector is not displayed, select Menu Properties.
2. Select one or more center marks.
3. In the Properties Inspector All tab, under Geometry, select Cross Size.
4. Specify a new value.