PDFADJUST (Command)

Adjust the fade, contrast, and monochrome settings of a PDF underlay.

Access Methods

 Toolbar: PDF Underlay visor Fade or Monochrome
 Toolbar: Properties Inspector Contrast, Fade, or Monochrome

Summary

If you select a single PDF underlay, the default values for Fade, Contrast, and Monochrome are the current property settings of the selected underlay. If you select multiple underlays, the default values for Fade, Contrast, and Monochrome remain as they were set the last time the command was used.

Note: Use the Properties Inspector to control if the colors of an underlay are adjusted for the current background color.

List of Prompts

The following prompts are displayed.

Fade

Controls the fade effect of the underlay. Values range from 0 through 100, default value is 0. The greater the value, the lighter the linework in the underlay appears. Works indirectly with the contrast effect; a higher contrast value blends the underlay in the background when fade is set to a higher value.

Contrast

Controls the contrast, and indirectly the fading effect, of the underlay. Values range from 0 through 100, default value is 100. The greater the value, the more each pixel is forced to its primary or secondary color.

Monochrome

Controls the color saturation of all linework while maintaining the luminance. When turned on, the linework appears in varying shades of gray starting at black if the background color luminance is 50 percent or more. If the background color luminance is less than 50 percent, then the colors are inverted, with the darkest linework displaying in white, and the lightest linework displaying in black.