To Work With Creating Solid Wedges

Create a Solid Wedge Based on Two Points and a Height

1. Click Modeling tab > Solid panel > Solid drop-down > Wedge.
2. Specify the first corner of the base
3. Specify the opposite corner of the base
4. Specify the height of the wedge.

Create a Solid Wedge With Equal Length, Width, and Height

1. Click Modeling tab > Solid panel > Solid drop-down > Wedge.
2. Specify the first corner or enter c (Center) to set the center point of the base.
3. At the Command prompt, enter c (Cube). Specify the length of the wedge and a rotation angle. The length value sets both the width and height of the wedge.