Places a hole at a specified distance from 2 contour lines.
Find
Summary
You typically use this command to draw a hole in a corner. If required, you can choose to draw a centerline cross only.
List of Prompts
The following prompts are displayed.
Dialog box
Displays the Centerlines dialog box, using which you can change the centerline creation method.
First contour line
Selects the first of two lines required to define a corner.
Second contour line
Selects the second of two lines required to define a corner.
Offset from first contour line
Specifies the distance from the first line to the center of the hole to draw.
Offset from second contour line
Specifies the distance from the second line to the center of the hole to draw.
Diameter of hole
Specifies the diameter of the holes to draw on the pitch circle. Enter S to specify that you want to select the hole from the standard part content library. Specify "No hole" to create centerline crosses without the holes.
Centerline cross diameter
Specify the diameter of the centerline cross to place on the hole.