Daylight Subassemblies

Use these subassemblies to add daylight to road assemblies.

Image	Subassembly	Common Uses
	DaylightBasin: Creates a basin in a cut situation or a basin, berm, and fill slope for a fill situation. Basin walls are comprised of two slope segments whereas ditches only contain one. Default Tool Palette: Daylight Subassemblies	Daylighting where a basin or ditch is required
	DaylightBasin2: Similar to DaylightBasin except that the berm is optional in a fill condition and the berm and basin widths can be controlled by an alignment. Default Tool Palette: Daylight Subassemblies	Daylighting where a basin or ditch is required
	DaylightBench: Creates cut of fill slopes with repeating benches as needed. Default Tool Palette: Daylight Subassemblies	Large cut or fill slopes where benching is required
	DaylightGeneral: Generalized daylight solution providing many parameters to create a basin, ditch, or simple daylight condition. It also includes an optional guardrail. Default Tool Palette: Daylight Subassemblies	General purpose daylighting
	DaylightMultipleSurface: Allows varying cut slopes depending on the material type being excavated. Up to three surfaces can be specified (i.e. topsoil, clay, rock). Default Tool Palette: Daylight Subassemblies	Deep cuts where multiple material types are encountered
	DaylightRockCut: Daylights using two target surfaces (existing ground and rock) with varied slope and ditch solutions based on conditions encountered. Default Tool Palette: Daylight Subassemblies	Daylighting for deep cuts
	DaylightStandard: Daylighting which applies one of 3 preset slopes (Flat, Medium, and Steep) based on conditions. It creates a ditch in cut situations and an optional guardrail for widening or steep fill conditions. Default Tool Palette: Daylight Subassemblies	General purpose daylighting

Image	Subassembly	Common Uses
	DaylightInsideROW: Daylights using a typical slope as long as the daylight is within the ROW limits. If the daylight falls outside the ROW, the slope can be steepened or held based on other parameters. Default Tool Palette: Daylight Subassemblies	Subdivision road daylighting
	DaylightMaxOffset: Typical slope is applied unless a steeper slope is needed to stay within a maximum offset from the baseline. Default Tool Palette: Daylight Subassemblies	Daylighting within a boundary or obstacle
	DaylightMaxWidth: Similar to DaylightMaxOffset except that the width of the daylight area is used instead of an offset from the baseline. Default Tool Palette: Daylight Subassemblies	Daylighting within a boundary or obstacle
	DaylightMinOffset: Typical slope is applied unless a less steep slope is needed to stay outside of a minimum offset from the baseline. Default Tool Palette: Daylight Subassemblies	Daylighting outside of a boundary or obstacle
	DaylightMinWidth: Similar to DaylightMinOffset except that the width of the daylight area is used instead of an offset from the baseline. Default Tool Palette: Daylight Subassemblies	Daylighting outside of a boundary or obstacle
	DaylightMultiIntercept: Daylighting that forces the cut or fill slope to pass through the surface multiple times to intersect at a more distant location. Default Tool Palette: Daylight Subassemblies	Daylighting in "rough" terrain where a different intercept point may be needed
	DaylightToOffset: Daylights from the attachment point to a given offset from the baseline. Default Tool Palette: Daylight Subassemblies	Daylighting directly to a boundary or feature
	DaylightToROW: Similar to DaylightToOffset except that an offset adjustment can be applied so that daylighting occurs a given distance within or beyond the ROW offset. Default Tool Palette: Daylight Subassemblies	Daylighting directly to a boundary or feature