To Create a Curve on a Figure Using Point of Curvature

Specify that the next shot is a Point of Curvature (PC) in the current figure. The shot immediately following the next shot is on the Point of Tangency (PT). This command creates a tangential arc from the last leg in the figure.

  1. In Toolspace, on the Survey tab, right-click a named network Survey Command Window.
  2. At the Command line, enter:

    PC

Command Line Example

PC

AD 13 30 25 ! Shot on PC

AD 14 33 24 ! Shot on PT

END

The following illustrates the Point of Curvature command:

Command Syntax

PC