Create slots in sketch.

Description

This sample demonstrates several new methods to create sketch entities that represent slots. These are the equivalent to new sketch commands that were added in Inventor 2014.

Code Samples 

Public Sub CreateSlots()
    ' Create a new part.
    Dim partDoc As PartDocument
    Set partDoc = ThisApplication.Documents.Add(kPartDocumentObject, _
                  ThisApplication.FileManager.GetTemplateFile(kPartDocumentObject))
    Dim partDef As PartComponentDefinition
    Set partDef = partDoc.ComponentDefinition
                  
    ' Create a 2D sketch on the X-Y plane.
    Dim sketch As PlanarSketch
    Set sketch = partDef.Sketches.Add(partDef.WorkPlanes.Item(3))
    
    Dim tg As TransientGeometry
    Set tg = ThisApplication.TransientGeometry
    
    Dim pi As Double
    pi = Atn(1) * 4
    
    Dim results As SketchEntitiesEnumerator
    Set results = sketch.AddArcSlotByCenterPointArc(tg.CreatePoint2d(0, 0), tg.CreatePoint2d(6, 0), pi / 2, 2)
    
    Set results = sketch.AddArcSlotByThreePointArc(tg.CreatePoint2d(15, 0), tg.CreatePoint2d(12.5, 2), _
                                                   tg.CreatePoint2d(10, 0), 2)
    
    Set results = sketch.AddStraightSlotByCenterToCenter(tg.CreatePoint2d(0, 10), tg.CreatePoint2d(6, 10), 2)
    
    Set results = sketch.AddStraightSlotByOverall(tg.CreatePoint2d(10, 10), tg.CreatePoint2d(16, 10), 2)
                                
    ThisApplication.ActiveView.Fit
End Sub