Sets parameters for the design of a bevel gear.
|
Access: |
Ribbon:
Design tab
Power Transmission panel
Bevel Gear
|
Common
|
Determines general specifications of the bevel gear. |
|
|
Face width |
Specifies face width. |
|
Helix Angle |
Specifies helix angle. You can insert only positive values from 0 to 55. To change direction, click Flip next to the edit field. |
|
Helix Angle Flip |
Switches helix direction. |
|
Shaft Angle |
Specifies the angle between shaft axis. |
|
Unit Correction Distribution |
Specifies the method for calculation of the teeth correction. |
|
Preview |
Displays the schematic image of the bevel gear dimensions. Click Gear 1, Gear 2 to see appropriate calculated results. Note: For description of the calculated parameters in the Results area, see Engineer's Handbook.
|
Gear 1, Gear 2
Specifies the type of gear (Component, no model) and the placement of gear.
There are two options for the method to insert the bevel gear. According to your selection, commands for placement are enabled in the Gear 1 and Gear 2 boxes.
- Component - new component is created.
- No Model - inserts only calculation.
|
Cylindrical Face |
Select cylindrical face. |
|
Start plane |
Select start face or work plane. Use Flip to flip the planar face or work plane |
(More)
|
Click More in the right lower corner of the Design tab to display additional options for bevel gear design. |
|
|
Input Type |
|
|
Gear ratio |
Calculates number of teeth of the second gear according to gear ratio. |
|
Number of Teeth |
Calculates the gear ratio according to number of teeth. |
|
Size Type |
|
|
Module |
Calculates the diametral pitch. |
|
Diametral Pitch |
Calculates the module. |
|
Unit Tooth Sizes |
|
|
Check the Gear 2 box to enter values for Gear 2. |
|
Results
To display the Results area on the right side of the Calculation and Design tabs, double-click the double line on the right or click the chevron.
Displays the calculated values and the key strength check. Values are calculated when Calculate is pressed.
To change the units of the results values, double-click the specified value you want to change.
For description of the calculated parameters in the Results area, see Engineer's Handbook.
Summary of Messages
Displays the reports about calculation. To open the Summary of Messages at the bottom of the Calculation and Design tabs, double-click the double line at the bottom of tabs or if you click the chevron.
Graphical Preview
Graphical preview of the designed bevel gear is presented in the Autodesk Inventor window when you specify the bevel gear placement (cylindrical face must be selected). Preview changes according to changes made in Bevel Gears Generator.