WEDGE (Command)

Creates a 3D solid wedge.

Find

The direction of the taper is always in the positive X-axis direction of the UCS.

Entering a positive value draws the height along the positive Z axis of the current UCS. Entering a negative value draws the height along the negative Z axis.

The following prompts are displayed.

First corner
Sets the first corner of the wedge base.
Other corner
Sets the opposite corner of the wedge base, located on the X,Y plane.
Center
Creates the wedge by using a specified center point.
Cube

Creates a wedge with sides of equal length.

Length

Creates a wedge with length, width, and height values you specify. The length corresponds to the X axis, the width to the Y axis, and the height to the Z axis. If you pick a point to specify the length, you also specify the rotation in the XY plane.

Height
Sets the height of the wedge. Enter a positive value to draw the height along the positive Z axis of the current UCS. Enter a negative value to draw the height along the negative Z axis
2Point (height)
Defines the height of the wedge by specifying the distance between two points