BOX (Command)

Creates a 3D solid box.

Find

The following prompts are displayed.

First Corner

Starts the box by setting the first corner.

Other Corner
Sets the opposite corner and height of the base of the box.
Cube
Creates a box with sides of equal length.
Length

Creates a box with length, width, and height values you specify. The length corresponds to the X axis, the width to the Y axis, and the height to the Z axis.

Entering a positive value draws the height along the positive Z axis of the current UCS. Entering a negative value draws the height along the negative Z axis.

The base of the box is always drawn parallel to the XY plane of the current UCS (work plane). The height of the box is specified in the Z-axis direction. You can enter both positive and negative values for the height.

Center

Creates the box by using a specified center point.

Cube

Creates a box with sides of equal length.

Length

Creates a box with length, width, and height values you specify. The length corresponds to the X axis, the width to the Y axis, and the height to the Z axis.

Cube

Creates a box with sides of equal length.

Length

Creates a box with length, width, and height values you specify. If you enter values, the length corresponds to the X axis, the width to the Y axis, and the height to the Z axis. If you pick a point to specify the length, you also specify the rotation in the XY plane.

2Point

Specifies that the height of the box is the distance between the two specified points.