AMSEALS2D (Command)

Inserts a seal or O-ring and draws the corresponding groove on a shaft.

Find

Summary

You can place seals on the outer contour of a shaft or place O rings on the shaft, inside a hollow shaft, or on the plane surfaces of a shaft. A wizard enables you to select the type of seal/O-ring and the view to insert. If the system cannot find a seal/O-ring to fit the shaft, you can select a size from a list of available sizes and resize the shaft to fit.

Use the Select a Shaft Seal dialog box to select the type and the view to insert.

List of Prompts

The following prompts are displayed:

Insertion Point

Specifies a point on a shaft contour to insert the groove.

Centerline

Specifies the centerline around which the command draws the groove and O ring or seal.