Use the Drawing dialog box to define only the geometry of the spring in the drawing.
|
Wire diameter d Enter a spring wire diameter or click on the measure button and determine this value from the graphic area. |
|
Da Specifies the Outer Diameter of the spring. Enter a value or click on the measure button and determine this value from the graphic area. |
|
n Specifies the total Number of Coils of the spring including the ends of coils. Enter a value. |
|
Helix Direction Select one of two spring helix directions: Right, or Left. |
|
End Coils Enter a total number of end coils for both spring ends. |
|
Closed Ends Use this check box to define closed or open ends of spring. |
|
Spring end shapes button From the Type of Ends dialog box, select the required spring end type. There are three types of compression spring ends: Ground, Round and Forged. |