Use this dialog box to enter parameters shaft bending moment in Shaft Component Generator.
- Access
-
- Ribbon: Design tab
Power Transmission panel Shaft. Click the Calculation tab, in the Loads & Supports drop-down list select Loads, and in the toolbar click Add Bending Moment.
- On the Loads & Supports area of the Calculation tab, select Bending Moment in the tree control, and click Loads properties.
- Double-click the load preview in the Autodesk Inventor window.
- Ribbon: Design tab
- Properties
- Enter the value for distance measured from the beginning, middle, or end of the section defined by active position marker.
- Moments
- Depending on your selection, Moment with angle or Moment in X and Y axes, the additional options display in lower part of the area.
- Moment with angle
- Bending Moment enter the value of the bending moment.
Angle enter the angle value.
- Moment in X and Y axes
- Bending Moment in Y axis enter the value of the bending moment in the Y axis.
Bending Moment in X axis enter the value of the bending moment in the X axis.