PowerMill 2025.0.1 update
The fixes in PowerMill 2025.0.1.
| Toolpath fixes |
| A problem has been fixed that could cause excessive tool engagement in Vortex toolpaths using a triangle block. PMILL-16885 |
| Problems have been fixed that could result in unsafe moves remaining in the toolpath after using Collision Avoidance. PMILL-22031, PMILL-22278, PMILL-22337, PMILL-22341 |
| A problem has been fixed that could prevent the completion of a toolpath calculation that used the Automatic method of Collision Avoidance. PMILL-21946 |
| A problem has been fixed that could impair the consistency of passes in toolpaths calculated using the Automatic method of Collision Avoidance. PMILL-21812 |
| A problem has been fixed that could cause PowerMill to close unexpectedly when calculating a Steep and Shallow Finishing toolpath. PMILL-20562, PMILL-22211 |
| A problem has been fixed that could prevent shallow areas from being machined completely by a Steep and Shallow Finishing toolpath. PMILL-15298 |
| Problems have been fixed that impaired the quality of Flowline toolpaths calculated with Stepover Calculation set to Tool Tip. PMILL-22030, PMILL-22172, PMILL-22173, PMILL-22231 |
| A problem has been fixed that could slow the calculation of a Raster Finishing toolpath. PMILL-22036 |
| General fixes |
| An issue preventing the context-sensitive help from being displayed has been resolved. PMILL-22317 |
| If PowerMill was installed through Custom Install on Autodesk Account, the shortcut to launch PowerMill may contain localised versions of the path "Program Files". In the initial release of PowerMill 2025, this caused PowerMill to not start correctly. This issue has now been resolved by making PowerMill tolerant of the localised paths. PMILL-22310 |