To route with offset alignment

1. On the ribbon, click Home tab Elevation & Routing Line Center (current alignment).
2. Click a justification from the drop-down list (for example: Bottom Left).
3. On the ribbon, in the horizontal Offset box, enter a horizontal offset (for example: 24).

   You can use a negative number to offset in the opposite direction.

4. On the ribbon, click Part Insertion panel Route Pipe.
5. In the drawing, click to specify a start point that is aligned with another object (for example: at a wall).
6. In the drawing, click to specify the next point of the pipe (for example, at a wall corner).
   
7. At the command prompt enter p (plane). In the drawing, click to specify the next point of the pipe.