Adds a conduit.
The following prompts are displayed.
Specify the starting point to insert the conduit segment.
Specifies the routing preference of the conduit. This is used to draw accurate runs in auto layout (based on the connection type).
Specifies the system and its abbreviations for the part. This may determine the layer placement.
Specifies the dimension, based on the outside and inside diameters of the conduit (as shown). Nominal size (also referred to as trade size) complies with industry standards.
Specify whether or not to lock the nominal size of an existing pipe or fitting. (Unlocked by default).
Specify the elevation above or below the XY plane of the object.
Specify the justification setting for a conduit segment.
Specify whether to enable or disable the compass.
A 3D surface or 2D line that can be used as a reference to constrain or offset the conduit run, when it is difficult to place geometry parametrically.
Specify the fitting routing angle.
Specify pitch of the drawn segment.
Specify conduit to match.
Ends the current duct run and start a new duct run.
Opens the conduit layout preferences.
Undoes the previous action.