DUCTTRANSITIONUTILITY (Command)

Add a duct transition to connect two duct segments that are not collinear.

Find

The Duct Transition Utility is used to connect two parallel ducts, duct fittings, or MvParts of different shapes, sizes or elevations. The DTU builds a duct transition - offset fitting to connect the two parts.

The following prompts are displayed.

Select first duct, duct fitting or MvPart

Specify the first duct, duct fitting or Mvpart to connect.

Select second duct, duct fitting or MvPart

Specify the second duct, duct fitting or Mvpart to connect.

Base point

Specify the base point to connect the two duct segments.

Copy

Specify a point location to copy.

Undo

Undoes the previous action.

Exit

Exits the command.