Creates one or more conduit runs parallel to a baseline pipe run as you draw it.
Using this command, you can create additional instances of the previously created wire and edit its properties.
The following prompts are displayed.
Specify the baseline pipe.
Specify the parallel conduit segment.
Specify next points in the run.
Specify the nominal size of the pipe.
Specify whether or not to lock the nominal size of an existing pipe or fitting. (Unlocked by default).
Specify the value for height and offset to draw wires with arc.
Specify the absolute or relative elevation of the pipe.
Specify orientation to justify the pipe object.
Specify whether to enable or disable the compass.
A 3D surface or 2D line that can be used as a reference to constrain or offset the conduit run, when it is difficult to place geometry parametrically.
Specify the rotation for the angle.
Specify pipe to match.
Specify a new baseline.
Opens pipe layout preferences.