Tolerance dialog box

In the Tolerance dialog box, you can enter individual chain element dimensions and tolerances.

Access:

Ribbon: Design tab

Power Transmission panel

Tolerance Calculator . On the Calculation Tab, Dimension List box, click Edit.

	Confirms the tolerance inputs.
	Closes the Tolerance dialog box.

Name:	Enter the tolerance name.
Model value:	Displays the computed value of the selected dimension. You cannot change the value in this dialog box.
Tolerance
Redefines the tolerance type and value for the selected dimension. Click the arrow and select from the list.
Type:	Specifies the tolerance type. The tolerance method determines which tolerance values are available. Click the arrow and select from the list.
Upper:	Sets the value for upper tolerance.
Hole:	Sets the tolerance value for the hole dimensions when using Limits and Fits tolerance. Click the arrow and the tolerance from the list.
Lower:	Sets the value for upper tolerance.
Shaft:	Sets the tolerance value for the shaft dimensions when using Limits and Fits tolerance. Click the arrow and the tolerance from the list.