Use this dialog box to specify the 3D preview settings and visibility of 2D preview in the Design and Calculation tabs in Shaft Component Generator.
Ribbon: Design tab Power Transmission panel
Shaft
and in the Design or Calculation tab, click Options.
Specify the visibility of 3D edge features.
Show: Section edge feature is always visible.
Hide: Section edge feature is hidden.
Show Only for Selected Section: 3D edge feature is visible for selected section only.
Specify the visibility of 3D middle features.
Show: Section middle feature is always visible.
Hide: Section middle feature is hidden.
Show Only for Selected Section: 3D middle features is visible for selected section only.
Specify the visibility of 3D bores.
Show: 3D bores is always visible.
Hide: 3D bore is hidden.
Show Only for Selected Section: 3D bores is visible for selected section only.
Specify the visibility of bore edge features.
Show: Bore edge feature is always visible.
Hide: Bore edge feature is hidden.
Show Only for Selected Section: Bore edge feature is visible for selected section only.
Specify the visibility of bore middle features.
Show: Bore middle features is always visible.
Hide: Bore middle features hidden.
Show Only for Selected Section: Bore middle features is visible for selected section only.
Select to apply the same settings for 2D preview on the Design and Calculation tabs.
Select to create 3D preview of the shaft in the default position in the graphics window.
Select to show 3D shaft coordinate system.
Select to scale supports and loads while zooming, and set the scale value.
Select to always hide 2D preview. 2D preview is hidden in the tab (Design or Calculation) where you made the selection. It means that you can have 2D preview hidden independently in Design and Calculation tabs.
Select to always show 2D preview. 2D preview is shown in the tab (Design or Calculation) where you made the selection. It means that you can have 2D preview shown independently in Design and Calculation tabs.
Select to scale supports and loads while zooming, and set the scale value.
Select to show section features in the HTML report.
Select to show bores and bore features in the HTML report.
Select to show loads and supports in the HTML report.
Select to display section features (keyway, groove, wrench opening, for example) in the 2D preview in the Calculation and Graph tabs.
Select to display bores and bore features in the 2D preview in the Calculation and Graph tabs.
Select to show the loads and supports designation such as F1, F2, q1 in the 2D preview in the Calculation and Graph tabs.