Bending Moment Dialog Box

Use this dialog box to enter parameters shaft bending moment in Shaft Component Generator.

Access

• Ribbon: Design tab Power Transmission panel Shaft. Click the Calculation tab, in the Loads & Supports drop-down list select Loads, and in the toolbar click Add Bending Moment.
• On the Loads & Supports area of the Calculation tab, select Bending Moment in the tree control, and click Loads properties.
• Double-click the load preview in the Autodesk Inventor window.

Properties

Enter the value for distance measured from the beginning, middle, or end of the section defined by active position marker.

Moments

Depending on your selection, Moment with angle or Moment in X and Y axes, the additional options display in lower part of the area.

Moment with angle

• Bending Moment enter the value of the bending moment.
• Angle enter the angle value.

Moment in X and Y axes

• Bending Moment in Y axis enter the value of the bending moment in the Y axis.
• Bending Moment in X axis enter the value of the bending moment in the X axis.