Sets parameters for calculation of a butt solder joint.
Access: | Ribbon: Environments tab ![]() ![]() ![]() |
Loads
Specifies the force carried by the joint or for the torque in the stepped joint. The direction of load action is shown in the diagram of the solder joint in the dialog window.
Dimensions
Specifies dimensions of connected materials. The picture of the weld joint contains the most important geometric joint dimensions specified in the Dimensions section. Forces and moments which load the joint and which are entered in the Loads section, are represented in the same way.
Results
Presents assessments of the joint strength, including the results of the strength check in the Results section. If input parameters are changed, refresh the values in this section by clicking Calculate (F5 key).
Summary of Messages area
Displays the reports about calculation. To open the Summary of Messages area at the bottom of the tab, double-click the double line at the bottom of tabs or click the chevron.