To Use Content Center Filters

Use filters to view only selected standards, manufacturers, or categories.

To turn on a filter, on a Content Center dialog box, click the down arrow next to Filters, and then select an existing filter.
To turn off a filter, on a Content Center dialog box, click the down arrow next to Filters, and clear the check mark for the filter.

Notes:

The active filters are applied when you use Search.
Filters can decrease the performance of Content Center.

Tip: If you do not use a Content Center library, remove the library in the Configure Library dialog box. The library is disconnected, and the performance of Content Center increases.

Add, edit, or remove filters

On the Content Center Library dialog box, click the down arrow next to Filters, and select Add/Edit Filters.
In the Filters dialog box:
- To add a custom filter, click Add, and enter a name for the new filter.
- To edit a filter, select the filter in the Filter Group Name.
- To remove a filter, select the filter, and click Remove. Then skip following two steps.
On the Standard tab, select manufacturers and standards to include in the view.
On the Categories tab, expand the category structure, and select categories to include in the view.
Click OK to save changes and close the dialog box, or click Apply to save changes and continue working in the Filters dialog box.

After you click OK, the filter selected in the Filters dialog box is automatically switched on.