Tolerances (for DIN standard) dialog box

Specifies the tolerance class and fit class in Involute Spline Connection Generator.

Access:

Ribbon: Design tab

Power Transmission panel

Involute Splines. In the Involute Spline Connection Generator, click

next to the Length edit field.

OK	Confirm the selection and close the dialog box.
Cancel	Closes the dialog box.

Centering to Groove Sides
Set the tolerance grades for shaft and groove.
Test Dimensions Settings
User	Check the box to enter the user values. If the box is not checked, the values are calculated according to the appropriate standard.
Pin Diameter, Shaft	Pin diameter on the shaft.
Finishing of Flanks
Select the way the grooves on the shaft and hub are created.