** ERROR 99984 ** This model is unsuitable for a Dual Domain analysis (reason)
When preparing the Dual Domain model for analysis, one of the following errors occured.
MATCH NOT DONE
Surface matching could not be done
Element matching could not be done.
NO MESH FOUND
The surface has not been modeled.
The model had not been meshed and so could not be refined.
EMPTY UDM
The model file is empty.
BAD QUALITY
The model surfaces could not be matched because the model contains a large number of imperfections.
Elements could not be matched because the model contains a large number of free edges or high aspect ratio elements.
FORCED THICKNESS
The forced thickness that was applied to elements in the model, caused the analysis fail.
FORCED STATUS
The forced status that was applied to elements in the model, caused the analysis fail.
Repair the error and re-run the analysis. If the problem persists, contact support.