FabricationPart.StretchAndFit Method

Stretch the fabrication part from the specified connector and fit to the target routing end.

Namespace: Autodesk.Revit.DB
Assembly: RevitAPI (in RevitAPI.dll) Version: 26.4.0.0 (26.4.0.0)

Syntax

C#

public static FabricationPartFitResult StretchAndFit(
	Document document,
	Connector stretchConnector,
	FabricationPartRouteEnd target,
	out ISet<ElementId> newPartIds
)

Parameters

document Document: The document in which to perform the stretch and fit.
stretchConnector Connector: The connector of the fabrication part to be stretched.
target FabricationPartRouteEnd: The target routing end to align and fit to.
newPartIds ISet<ElementId>%: New fabrication part element identifiers.

Return Value

FabricationPartFitResult
Returns FabricationPartFitResult::Success if successful.

Exceptions

Exception	Condition
ArgumentException	Connector does not belong to a fabrication part with a valid fabrication service. -or- Connector is connected. -or- Connector belongs to a fabrication part straight, tap, or hanger. -or- Routing end is valid to route to. -or- stretch target end type must be a supported type.
ArgumentNullException	A non-optional argument was null
InvalidOperationException	fabrication part is not connected at one end only. -or- cannot stretch fabrication part to a different service.

Remarks

Cannot stretch and fit fabrication part straight, tap or hanger.