On the Machine Editor dialog, the Controller tab lets you specify a variety of options that affect the Post Processor, as well as parameters that affect the NC that is being written.
The following options are available on the Controller tab:
Use Post Processor Library: This field specifies the external .VPL file (externally hard-coded post processor file) associated with a specific machine. This field is grayed out (not selectable) for generic machines. For more information on VPL files and this field, see Before Installing a New Machine.
File Extension: The default file extension used by the router controller is automatically specified in this field, but it can be edited if desired.
Motion: Most router machines use code written in Absolute Mode. Ensure that this is selected in the Motion box or changed to Relative if advised by the machine supplier.
Machine Zero Offset: There is typically no need to enter a value in this field.
Override Main Units - Convert To: It is possible to convert the NC to Imperial (if working in Metric) or to Metric (if working in Imperial), though this is not usually necessary unless the Main Database is not configured correctly.
Conversion Multiplier: For the Axyz Configuration, the Conversion Multiplier is set to 1.
Decimal Places (NC Data): When working in Metric, the Decimal Places (NC Data) set to 2. In an Imperial setup this is set to 3.
Automatic Loading: If Automatic Loading is supported by the router machine, the nest sheet number is automatically loaded into the Job after the first sheet has finished cutting.