| DoubleHemFeatureDefinitionType |
6 |
A double hem is where the edge is bent over twice to form a hem that doubles back on itself. |
| FlatHemFeatureDefinitionType |
1 |
A flat hem is like an open hem but the gap is closed and the edge is flattened against the main sheet. |
| OpenHemFeatureDefinitionType |
2 |
An open hem is simple bend along an edge that leaves a gap between the hem and the main sheet. |
| RolledHemFeatureDefinitionType |
3 |
A rolled hem is where the edge is rolled over to form a tube-like profile. |
| RopeHemFeatureDefinitionType |
5 |
A rope hem is where the edge is rolled over (like a rolled hem) with an added length after the roll parallel to the main sheet. |
| TeardropHemFeatureDefinitionType |
4 |
A teardrop hem is where the edge is bent around a diameter to form a teardrop like profile. |
| UndefinedHemFeatureDefinitionType |
0 |
The hem type is undefined. This occurs when a new HemFeatureInput is created and before a specific type has been defined. |