Retract height

Retract height sets the height that the tool moves up to before the next cutting pass. Retract height should be set above the Feed height and Top. Use Offset to shift the height from the reference selected in From. A positive or negative offset moves the height in either direction.

Retract height.

From

• Clearance height - Incremental offset from the Clearance Height.
• Feed height - Incremental offset from the Feed Height.
• Top height - Incremental offset from the Top Height.
• Bottom height - Incremental offset from the Bottom Height.
• Model top - Incremental offset from the Model Top.
• Model bottom - Incremental offset from the Model Bottom.
• Stock top - Incremental offset from the Stock Top.
• Stock bottom - Incremental offset from the Stock Bottom.
• Selection - Incremental offset from a Point (vertex), Edge, or Face selected on the model.
• Origin (absolute) - Absolute offset from the Origin that is defined in either the Setup or in Tool Orientation within the specific operation.

Drill only:

• Hole top - Incremental offset from the Hole Top.
• Hole bottom - Incremental offset from the Hole Bottom.
• Hole segment top - Incremental offset from the top of the selected hole segment.
• Hole segment bottom - Incremental offset from the bottom of the selected hole segment.