About QuickRoute tools

Use QuickRoute Airwire to route a selected signal from start to finish.

Use QuickRoute Signal to route a group of signal segments with the same name. A limit with this command is that it does not run on a signal that has more than 16 segments.

Use QuickRoute Multiple to route a group of signals from a set of related pads, such as parallel pads on the side of a chip.

Use QuickRoute Smooth to reroute a signal to the simplest path, with the minimum bends and segments.

Use QuickRoute Guided to guide the routing of a group of signals from a set of related pads. This option provides better control where the trace corners occur, such as when going around another component on the board. It can also run traces from one layer to another.