Create a Mesh Wedge Based on Diagonal and Height
- Click
. Find - Specify the first corner of the base.
- Specify the opposite corner of the base.
- Specify the height of the wedge.
Create a Mesh Wedge Based on Length, Width, and Height
- Click . Find
- Specify the first corner of the base.
- At the Command prompt, enter L (Length). Specify the length of the base.
- Specify the width of the base.
- Specify the height of the wedge.
Create a Mesh Wedge With Equal Length, Width, and Height
- Click . Find
- Specify the first corner or enter c (Center) to set the center point of the base.
- At the Command prompt, enter c (Cube). Specify the length of the wedge and a rotation angle.
The length value sets both the width and height of the wedge.
Create a Mesh Wedge Based on a Center Point, Corner of Base, and Height
- Click . Find
- At the Command prompt, enter c (Center). Specify the center point of the base.
- To set the location of a corner of the base, use one of the following methods:
- To set the length and width simultaneously: Specify the location of one corner of the base.
- To set the length and width separately: At the Command prompt, enter L (Length) and specify the length. Then specify the width.
- Specify the height of the wedge.