To Work With Trimming Surfaces

Trim a Surface

1. Click Surface tabCreate panelTrim.At the Command prompt, enter SURFTRIM.
2. Select the surface and press Enter.
3. Select the cutting curves and press Enter.
4. Select the surface areas to remove and press Enter.

   The selected areas are remove d.

Trim a Surface to a Projected Curve

Use this procedure to use geometry that visually intersects a surface from the current view as a cutting edge for trimming.

1. Click Surface tabProject Geometry panelAuto Trim.At the Command prompt, enter SURFACEAUTOTRIM. Then enter 1.
2. Click Surface tabProject Geometry panelProject to View.At the Command prompt, enter PROJECTGEOMETRY.
3. Select the object to project onto the surface and press Enter.
4. Select a surface as the target and press Enter.

Restore a Trimmed Surface

Use this procedure to restore geometry that was trimmed using SURFTRIM.

1. Click Surface tabCreate panelUntrim.At the Command prompt, enter SURFUNTRIM.
2. Select a visible part of the surface and press Enter.

   The trimmed areas are replaced.